BITUFIX® E

Ready-to-use slurry for the production of coatings and sealing of asphalt surfaces BITUFIX® E is a fine slurry based on polymer-modified bitumen emulsion

Application

BITUFIX® E Ready-to-Use Slurry is used as a bitumen/plastic composite slurry to remove heavily used asphalt surfaces, such as central seams, rough asphalt surfaces, crossing areas, smaller cracks and crack clusters, etc. The application is carried out in one or two work steps in accordance with ZTV bit-STB 90

processing

The ceiling surface must be carefully cleaned. The substrate must be level and well compacted. If it is very hot, the ceiling should be slightly moistened with water before applying the mud. Older asphalt coverings are given a primer as an adhesion promoter, eg Bitu adhesive. The slurry is stirred thoroughly before processing and, after the adhesion promoter has completely dried, spread evenly with a rubber squeegee and level off to zero. Since BITUFIX® E only hardens after the water has evaporated, the work should only be carried out in warm and dry weather. The outside and surface temperature should not fall below 10°C. Lower temperatures delay, higher temperatures accelerate the drying process. A second layer of slurry should only be applied after the first layer has completely dried. Slight color deviations from different batches are possible. This does not affect the properties of the sludge.

To increase the roughness, BITUFIX® E can be mixed with approx. 10% clay-free sand (grain size 0/2).

Consumption depending on the nature of the substrate

Simple sludge: approx. 0.8 - 1.5 kg/m²
Double slurry: 1st layer of slurry approx. 1.0 – 1.5 kg/m² 2nd layer of slurry approx. 0.6 – 1.2 kg/m²
Dilution water: 1 : 1

form of delivery

storage

Frost-free above 2°C
Can be stored for about 8 months unopened in the original container

Please note that the information in this publication corresponds to our current knowledge. Due to the large number of possible influences when processing and using our products, they do not release the processor from carrying out his own tests. A legally binding assurance of certain properties or the suitability for a specific purpose cannot be derived from our information. Existing laws and regulations are the responsibility of the recipient of our products.